How to remove subfloor

If removing the subfloor is damaging the hardwood then your best bet is probably just. Get ready for some hard work. Often these particle board sub floors are glued and stapled every six inches. I usually use a circular saw with an old carbide tipped blade with the depth set. Use what they call a cats claw to remove all the nails 1st.

Crow and pry bars along with a couple people working on the same sheet all at once. Peel back or remove any carpet or floor coverings. How to dry out subfloor? If there is floor underlay such as a thin layer of particleboard on top of the subfloor , you will need to pry that up and remove it. Hindsight: Ironically, on this job the underlayment was attached to the subfloor WAY better than the subfloor was attached to the floor joists.

In this quick video Bryan will demonstrate how to remove subfloor. First, set the blade depth on your circular saw. Removing vinyl from concrete is similar to removing it from subfloor. However, getting the adhesive off the concrete may prove to be more difficult. Start by scraping the glue with a pry bar or scraper.

If you catch the accident immediately, you may be able to remove the odor and salvage the subfloor. You need a plan to contain and remove the mold before you actually begin the removal process. The wooden subfloor should be completely smooth and solid before installing a new floor. In my case I need to remove some of the sub-floor in order to access plumbing. If you do not have to remove any subfloor then you should re-nail or better yet, screw down the sub-floor to ensure you create a good connection and eliminate squeaks and movement.

There are two main subfloor materials, plywood and concrete, and two separate instruction for each of them. Check the plywood subfloor for dark spots, soft areas, or cracks. If you notice any damage, use a skill saw to carefully cut outside of the area you need to remove. Repair the damaged area by nailing new marine plywood into the joists beneath the subfloor. This will make it almost impossible to lay down new carpet or tile correctly.

You need to remove the glue residue in order to replace your flooring. The surface of the subfloor must first be smoothed out to make the new flooring adhere correctly. Here are the steps to follow. Scrape the glue using a floor scraper. If you gently pry up the flooring and notice black mold on the joists, you will need to remove it right away.

Since spreading can be an issue on the joists, assistance from a professional may be beneficial. The subfloor is the hard material of your floor between the top layer and the floor joists. If the subfloor is covered in a layer of texture uneven adhesive chunks, new tiles will adhere to the glue rather than the subfloor , causing tiles to slip after installation. Although removing remaining glue remnants is somewhat time-consuming, completing this step is vital before applying new flooring. Then take your foot,preferably with a boot on it and stomp right on the cuts you made.

A nice clean surface is what you will have. Subfloor Repair Labor, Basic Basic labor to repair subfloor with favorable site conditions. Cut and remove damaged subfloor.

Fabricate and install new 2xsubfloor. Includes planning, equipment and material acquisition, area preparation and protection, setup and cleanup. To remove the linoleum and subfloor together, drill a hole through the floor to determine how thick the plywood is.

Use the claw hammer to remove the nail.