Astm c645

For Best Non-Structural Steel Stud Specifications, Stay. What is cold formed metal framing? What are the standard sizes for a metal stud? A number in parentheses indicates the year of last reapproval.

Members shall have a protective coating conforming to specification A6–Gminimum or shall have a protective coating with an equivalent corrosion resistance. The values stated in inch-pound units are to be regarded as standard. Complete Document Standard Specification for Nonstructural Steel Framing Members.

View Abstract Product Details. Application of Acoustical Materials and Systems. Current edition approved Sept. Originally published as C6– 69. Members shall be manufactured from steel having a minimum thickness, individual measurement of 0. The minimum base steel thickness was given which was based on meeting the width-to-thickness ratios of Chapter B of AISI S100.

The version currently published allows for a 0. To get current limiting height information, the manufacturer should be consulted for tables. Other Standards: ASCE Minimum Design Loads for Buildings and Other. Summary of Test Method 3. Asteel hammer impacts with a predetermined amount of energy, a steel plunger in contact with a surface of concrete, and the distance that the hammer rebounds is measured.

ASTM C6Section 4. Get the right product for the spec. For suspension system main tees, this deflectioncannot exceed 0. All BSI British Standards available online in electronic and print formats. Ideal for basement, attic and garage remodels. Will not warp or twist.

Apply gypsum board horizontally or vertically in single or multiple layers. Fasten Jamb Studs to Track Top and Bottom 2. Acoustical tile or lay-in panel ceilings shall also comply with the following a The width of the perimeter supporting closure angle or channel shall be not less than 2. CGC presents these data as a reference, but is not responsible for performance of the wall based on them. Loads Framing members and their installation must be selected according to their ability to withstand the loads to which they will be subjected.

It is referenced in IBC to determine code compliance for non-structural studs. Find the most up-to-date version of C6(RL) at Engineering360. This document has been replaced.

Corrosion prevention is an essential factor in the economical utilization of galvanized sheet metal for ceiling grid. Screw strength is another critical life-safety issue. For generic assembly fire rating information, please refer to UL Design No.

U33 U34 U36 U3and U375. Find submittal-ready datasheets, SDS, specs, ICC-ES reports. The steel framing and furring members covered in this specification are limited to those complying with Specification C645.