Position the awning rail along the roof line (line where roof and wall meet) or a minimum of above the upper edge of the door or windows the awning is covering. Park the vehicle on a flat surface and level the unit. Retract the awning. Observe if the centerline of the roll bar is level with or slightly higher than the centerline of the awning rail.
Refer to page Error! Bookmark not defined. The bottom of the roller tube must not be higher than the awning rail. Use all the attachment holes in the rail. Use a screwdriver to spread open the left end of the awning rail on the installation side.
File any sharp edges or burrs from the end of the rail. For the referenced Details, refer to Figure Replacing the Fabric on page 2. Followed your video to replace our awning. We bought an av used and the awing material had been removed except on the track of the camper and the tracks of the roller.
We purchased a new awning and after removing the scraps of awning both off the camper and roller we followed the instructions and replaced the awning. Great video and very complete. Thanks to Tyler of Tough Top Awnings for showing us how! The canopies are housed in an aluminum case that easily blends in with the coach roof.
Free 2-day Shipping On Millions of Items. Measure the distance from the awning rail to the bottom mounting brackets. Adjust the arm length so the distance from the center of the roller to the foot is approximately equal to the measurement in step 1. AWNING INSTALLATION A. Using a helper, raise awning so that arms are vertical and roller tube is approximately the same elevation as the awning rail.
Extend lower part of arm so that awning is same height as awning rail using the operating handles and rest awning on ground. Keep in mind that repairs or replacements that require exposing the springs can be dangerous. Their Simplicity Plus model is extremely popular, and is available in a variety of colors. Third: Upon opening the box with the mounting hardware, I could not find installation instructions for the awning.
Awning Fabrics are made to order and not returnable. It is critical that all brackets be mounted level, plumb and on the same surface plane. Awning Extrusions and Hardware - Free from defects. Watch a quick video demonstration on installing an RV awning , or go step by step through our guide below.
RGB color (color options) with white LED awning light. For use on standard roller tubes if awning is longer than ft. Flash, fade, and strobe light. Carefree super sport a wning insertion. The direct mount is basically for nonrecessed rooms with flat flanges, and there is a specific clearance requirement for the top.
Just follow these basic steps: Always operate the awning according to the instructions. This was the darndest thing. Periodically check that the fasteners are tight. Tighten if necessary.
Keep the awning fabric and arms clean.
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.