How to remove linoleum flooring

How do you remove old linoleum from a wood floor? What is the best way to clean linoleum? How to strip linoleum floors? Working in small sections, score the flooring into strips about to 12.

To fully remove linoleum , you’ll need to tackle both of its layers:. Other articles from bobvila. Vinyl flooring is made of several layers. This is a tough coating.

There are some products that help hide. Clear the work area. Cut the linoleum into 12-inch (3cm) strips using a sharp utility knife. Heat the linoleum topper with a heat gun.

Discard all tiles as you remove them. Loosen stuck tiles by carefully applying heat to the tile surface with a heat gun or a wallpaper steamer. Make the strips between and inches (1 and 3 centimeters) wide. Slowly move the heat gun back-and-forth over the small section to heat it. It will just curl right off the floor in very satisfying little strips.

Cut out the subfloor and linoleum or vinyl flooring as one piece. Since it’s easier to work with smaller strips, it helps if you score the linoleum or vinyl with a razor knife into 12” wide strips. Pour the boiling water onto the remaining linoleum and adhesive on the floor. Cover the floor with damp towels to keep the surface wet.

Start removing vinyl flooring right here, using a utility knife to cut the material into 12-inch strips. Pull up each one gently. Where you encounter resistance from the glue , use a scraper tool. Lift part of each strip with a flat, narrow, putty knife, and then pull off the rest, using the putty knife to help pry.

Continue removing the. After scoring the linoleum with a utility knife, I used a multi tool to pull the squares up. You can raise the setting later if necessary. Starting at one corner of the room, apply the heat gun to a section of adhesive until it softens.

Determine your subsurface. If you do not already know what kind of flooring lies underneath your linoleum , you will. Score the linoleum in straight lines, but do not dig the. Insert the edge of the floor scraper beneath the one of the cut marks in the linoleum.

Push forward with the. Fill a bucket with hot water, then pour it carefully onto your linoleum floor. Use a mop to spread the water over the entire floor. Remove old linoleum.

Allow the water to sit on the floor for about minutes. It helps to soften the adhesive used to attach the linoleum onto the concrete base. I’ve removed vinyl flooring with a handheld floor scraper, and I’ve done it with a rental oscillating floor scraper machine.

Then repeat scoring every in. Mix one part household bleach with four parts water, soak a rag in it and lay the rag over the stain. Oxalic acid is the solution for stubborn rust stains. It’s often labeled “wood bleach”—but not all wood bleach contains oxalic aci so check the label. To remove old vinyl, remove the transition strips (Image 1) that hold the carpet in place.

Use a heavy-duty scraper to remove the old vinyl (Image 2). The old vinyl will probably come up in small pieces and in some areas the paper backing separates from the vinyl itself and remains on the floor. Depending on how easy the tiles are to pry up, you may need either a crowbar or chisel and hammer to pop the tiles off the floor.