How to measure stairs for carpet

How to calculate how much carpet is needed for stairs? What is the best rug for stairs? How do you calculate square footage of stairs?

A box stair is straight, has no railing posts, and is closed in on all sides. It is typically approximately. It has the same measurements. Figure the area for one rise and one trea multiply by how many steps Ex. Depends on how the steps are done.

Is there a landing? Stretch out the measuring tape parallel to the edge of a stair to get the width. Carpet is usually measured in square yards. Do this for 2-stairs in case there are any variations in width. Then, multiply the step area by the total number of stairs in the staircase.

There is no need to measure additional steps as long as you know the measurement of the widest step. Round the number up to the nearest foot. To measure stairs, first of all double check a few of the stairs to make sure they are the same width and then measure the riser (height) and tread (depth) of one step.

This is the length vertically up and over the step. Multiply that measurement by the number of stairs that you have. Some stairs are wrapped over one or both sides, some have to be upholstered which may require additional material, some are pie shaped and are more difficult to measure , some have landings that must be considered. For stairs , measure one stair tread from one side to the other side of the rail (or wall) and then round it off to the nearest foot.

Then, measure the stair riser from the bottom to the top of the tread and round off to the nearest foot. Label the width as and the length as 2. A Few Examples Let’s start with a simple box stair. For a typical set of box stairs, you’ll multiply the 36” width by the 18” tread and riser, then multiply by stairs. Starting with the top step, measure the depth of the.

Combine the two measurements. The stair tread is the flat horizontal part that you step onto. Using your tape measure , measure the width and the depth of the tread and record each measurement.

If you are planning on using a carpet runner on your stairs that doesn’t cover the. GOLDEN RULES FOR STAINS AND SPILLAGES. NEVER USE WASHING UP LIQUIDS. Measure a stair tread. Scoop up solids with a knife or spoon.

ALWAYS blot up the spillage using white absorbent paper, until no more shows on the paper when pressure is applied. Before treating the stain, test treatments on an inconspicuous part of the. Hold your tape measure against the opposite wall (or halfway into a doorway), and wrap it all the way around the nosing until it touches the back (riser) of the stair below. Your carpet will need to be this measurement in order to wrap around the nosing.

If your home is larger or has a difficult floor plan it will be more difficult to measure. If you have stairs you can access my stair yardage chart in my ebook Visit my Room Yardage Chart - a helpful tool for helping you calculate how much carpet you need to buy.