How to install hardwood stairs

How to install new stair treads and railings? What does it cost to laminate stairs? A lot goes in to installing hardwood on stairs. In most home improvement projects, the skeleton of your stairs is already built, but the surface parts, the treads and risers, might need replacing. In this article, you’ll learn how to use hardwood planks to replace or cover your stairs ’ existing treads and risers.

Building a new staircase averages $400. Certain designs (such as L-shaped stairs ) need more framing, which can raise the price to at least $000. Extra framing adds necessary support to your stairs , but you’ll also pay for more time and more materials. To prepare for the stairs to be finishe cut back the lip on the existing treads and thoroughly clean the stairs with a vacuum.

Next use a tape measure (Image 1) and mark where cuts need to be made on each tread and riser, cutting at the marks with a miter saw (Image 2). To get an exact edge, use a grinder (Image 3). Step Use a table saw and start cutting the riser pieces to the correct size. If the existing plywood is in good condition, leave it for the strength. Place your risers on first, then cut your steps to overlap the riser by about an inch to an inch and a half.

Here are a few good sites with information and tools to. If you have no knowledge of this, I would suggest checking the internet, or book tutorials to learn what you need in order to accomplish this task. It would be difficult to cover the pine with hardwood because you would be changing the rise to run ratio in which the stair were calculated.

Your first and last treats would be different to the rest of the staircase which would make it. Aside of the many types of species, all types of hardwood can be installed on stairways. The latter is often chosen to match an existing area that may connect or is installed on concrete in the foyer of the home. Do not Pay to replace worn carpet with hardwood. Free 2-day Shipping On Millions of Items.

If the carpet or wood on your existing staircase has seen better days, try covering its risers and treads with unfinished hardwood. Measure each riser separately. Before you start to install hardwood stairs , it may be necessary to remove the existing hardwood stairs trea either to match the elevation of the floor at the top of the staircase or because the treads are damaged. The type of material to choose is a primary consideration. While stairs have been constructed using a variety of materials over the years, wood stairs remain the most common.

Typical construction stairs (ie. those under the carpet) are design with a lip on the front. Once, many, many years ago, while still young, thin, and energetic cubs, we accepted a customer’s request to install hardwood on their steps. Notice that young, thin, and energetic are not joined by my most valued adjective, smart.

More on that later. Ok, we decided we could do that. Fortunately, if you’re looking to change the look of your staircase, it is fairly easy to install engineered wood flooring on stairs even for beginning DIYers.

Yes, hardwood stairs price can be considerable, but it is worth the cost. We replaced our floors upstairs with beautiful new hardwoods, and that made these stairs look even worse. It was time to renovate our carpeted stairs. It ended up being a little more difficult than normal since we planned on installing hardwood flooring on stairs with an existing nosing, but I found an easy solution.

Secure 1st prefinished stair tread. Nail the back edge which will be disguised by the riser. Repeat steps through until you are done! Install 1st set of shims using adhesive and nails.