How to distress stained wood

What is the easiest way to distress wood? How to distress wood to make it look old? Plus, inexpensive wood is more likely to have knots and superficial damage, which can give you a head start on aging. Tip: Make sure you have some scrap wood for practice and experimentation, as any distress you add should be superficial, not structural.

It’s mind blowing how far paint has come over the years. Distressing new wood has never been easier or faster. Ladies, it’s time to ditch the stain and grab your makeup brushes. We’re about to stain, weather, and distress new wood with paint that dries in minutes.

Unsubscribe from lcfgroup? A heavy metal chain works well. It dents the wood without tearing. If you distress them before you apply stain the holes get much darker and stand out. I never spray painted distressed woo I think the paint would pool in the dents and.

Here is the easiest way in the world. Some people use a chain and hit the surface. Paint the light base coat in off. How distressed do you want it to be? Might need to sand off the edges where you would normally find wear (scuff it a bit).

Then, paint the piece white, opal, or eggshell and let it dry. Now the wood is ready to be painte including the places covered in wax. After the paint has drie use a paper towel to wipe off the paint from the waxed areas using a side to side motion. The wood grains will start to show from underneath the paint. Carry on as long as you are happy with the result.

Be careful if your project requires glue. If glue gets on an area that needs to be stained , it will resist the stain. Get A Long-Lasting, Durable Finish That Professionals Trust In Varathane. But if your furniture still has that youthful glow, there are several ways to distress the wood so you.

Next, give the furniture a new coat of paint, use coarse-grit sandpaper or a sanding block to achieve an uneven, weathered look, and apply the top coat of paint. To complete the procedure, you can apply a glaze, distress the wood or do both. That was all well and good … except I didn’t want to wait years for my lumber to turn that color.

For the bare- wood look: When the base coat is dry, start sanding off areas that would naturally end up distressed — places where hands would have held it, or corners that could easily get nicked. Steps: Mix paint and water to desired consistency (for this example, I used equal parts). Dip rag in mixture and apply it liberally to the wood as you would a stain, wiping over it with a rag to evenly distribute it. When you distress painted wood you want to keep in mind you can easily distress more as needed.

Don’t apply too much pressure and distress too much at a time. Slow and steady creates a gorgeous distressed furniture finish. Also, try to only distress areas that would naturally distress over time. Below is the simple process that you can use to give new wood a vintage, shabby chic, distressed painted look.

As mentioned in the video above, when I distress painted furniture I also like to sand the entire flat surface using 3grit sandpaper to create a smooth finish.