How to install led strip lights

If you buy the ones from walmart, auto zone, etc they normally have two options car charging port plug in ones, and hard wiring ones. Get the hard wiring ones since their going on your license plate. They have two wires the white one.

A push-to-break switch returns to its. How to install under cabinet strip lights? Peel the top layer off to expose the ends.

Slide the end of the strip into one end of a connector clip and snap it shut. Place a connector in the other side of the clip so the strip can lay flush along the corners. Measure the area where you plan on hanging the LEDs. Use plug-in quick connectors if you need to join separate LED.

Method of 4: Soldering. We can join and splice two LED strips together by soldering a wire to the ends. HomeAutomationX 688views. Install Your LED Strip Lights After picking your spot and you have enough room to install your LED strip lights, it is time to do the honors.

Start by cutting your strips to size then attach them to your ceiling. Remember to put a masking tape at the end of each piece for better recognition. RockingB 20views. If you’re installing your LED lights in a building with an overhead door, check for adequate clearance. LED Strip light enclosed trailer- what I have learned - Duration: 6:42.

With the door raise make sure the lights and wiring will be well clear of the door. This will prevent unnecessary foul language and a trip to buy replacement lights after they get sheared off the ceiling. Money Back Guarantee! Free Shipping Available. LED Strip Mounting Clips This is a simple, cheap solution for installing LED strips that does not rely on double sided tape.

These small clips use a one screw design to screw into surfaces and clip over the LED strip , holding it in place. Step 1: Double check your lights before cutting or installing. When installing LED strip lighting under your counters, cabinets, or inside coves, it is very important that you test the LED lights before any installation. Follow the steps below before you cut any of the lights or attach them to any surface.

JUYGovee LED strip lights -16. The diagram above shows great ways to install the LED light strips in your vehicle. I no longer recommend self-adhesive strips , even included on the light strips.

After being exposed to heat in a car’s interior they often fail. While LED light strips typically include a self-adhesive tape on the back of the strips , it’s often not reliable. DO NOT power strip lights while tightly coiled or attached to reel. DO NOT install strip lights where LED chips are exposed to direct sunlight. Always consult a wire gauge chart to determine the correct size wire for your application.

Begin by measuring the space under your cabinets to determine how much strip lighting you’ll need. Locate the power outlet you’ll use, or decide if you’ll hardwire the under-cabinet and above-cabinet lighting strips. Place your power supply inside the cabinet.

Cut your light strip to the size of your surface with a blade or scissors. Make your cuts following the guidelines. Peel off the entire adhesive backing if you are using shorter strips. The adhesive side of your LED strip is. Remove the adhesive backing as you go.

It’s important to cut right on this line to maintain the connection. Peel and stick the LEDs to the under-side of the cabinet above the sink. Screw the wireless touch pad’s bracket to the wall and install the switch and cover plate.

Now screw the terminal to the underside of the cabinet.