Refinishing a table

What is the best way to clean a wood table? How to refinish a mahogany table? If using an orbital or belt sander, be careful not to gouge the surface. Do most of the initial sanding and varnish removal with the 100-grit sandpaper, then step up to 150-grit and do a final pass with 220-grit to smooth out the grain for the new finish. Clean, clean, clean.

The biggest mistake first-timers make with refinishing is not spending enough time prepping the. How To Refinish A Table Step 1. When the mineral spirits dries, begin staining the furniture. Use fine-grade steel wool to brush the stain into. Buff the stain from the. There are two ways to refinish a table: sanding and stripping.

I’ll go over each method with the pros and cons of each one separately, so you can choose the right one for your project. Sanding is the best method of the surface of your table is worn or damaged. Refinishing a table can be a time-consuming process, and there a several ways to go about it. We wanted to refinish a table top that had worn considerably over time. Free 2-day Shipping On Millions of Items.

Keep in mind: Price and stock could change after publish date, and we may make money from these links. The first thing we did to refinish our dining table was take it apart haha! This was actually one of the most. Next we sanded that baby down using the 1grit paper. I was super worried to.

HGTV expert Steve Watson gives you a list of materials and step-by-step instructions for refinishing a wood dining room table. After we got the original finish off,. First, sand off the old finish. You might also consider routing the. Instructions Use KleanStrip Stripper to remove the old finish with a chip brush.

Use a plastic paint scraper to scrape away the old finish. A wire brush is needed to scrape away the finish from the table edge. Scrub it into the wood. The key is to lay down the poly in long, continuous strokes, one right after the other, so you always keep a wet edge. Don’t wipe on too much at one time.

Thin coats level out better and dry faster than thick ones. Most manufacturers recommend applying three coats, but I usually do more. Just like the sanding, applying your finish should always go with the grain. A thin consistent coat is the way to go. A thick coat will take longer to dry, more likely to be uneven coverage, and will attract more dust.

Wait the recommended drying time. Finishing a tabletop is tricky. On a big table especially, coating the entire surface before the finish becomes too sticky is the ultimate test of speed and skill. And your work has to be perfect. More than any other furniture surface, a tabletopreflects light and shows off every little flaw.

Removing decades of dirt and grime often restores much of the original luster. Kevin recommends liquid Ivory dish soap mixed with water. Get Refinished Table delivered to your door.

Furniture and accents for every room. Complete your space with Refinished Table from Target.